Auto Siphon Kit - Complete - Suit Grow Bed 200L to 600L - to 350mm Deep

Complete Auto Siphon Kit - Suits Aquaponic or Hydroponic systems with grow beds with 200L - 600L media capacity and up to 350mm media depth.

 

Kit comprises:

- PVC Outer Screen (gravel guard) with multiple 4mm horizontal slots.

- PVC Inner Capped "Bell" - Our design of this Inner Bell stops gravel and debri from entering the siphon.

- PVC Centre Standpipe set to allow 300-310mm max water level when grow bed fully flooded.

- PVC Threaded Faucet Socket. Fixes standpipe securely to grow bed and allows attachment of return pipe to fish tank, sump, reservoir etc.

- Heavy Duty Rubber Washer. Fits between faucet socket and grow bed. Ensures water tight seal where standpipe exits grow bed floor.

Please Note: While this siphon kit has been made to suit a gravel/media depth of 350mm and provide a maximum water depth in the media of 300-310mm, it can be altered to suit shallower grow bed/media depths.

This can be done by the purchaser at the time of installation as the cap is not glued onto the bell at the time of manufacture, ie: If your grow bed/media depth is only 320mm, then you would simply cut 30mm from the length of all three components, the outer gravel guard, the bell, and the standpipe. Once the correct size has been achieved the cap can then be glued onto the top of the bell to form a proper seal.

 

What is an Auto Siphon?...

An auto siphon is a very simple, yet ingenious piece of equipment that enables aquaponic and hydroponic growers to flood and drain grow beds automatically and continuously, without using timers, extra pumps or solenoids etc.

They are very simple and contain no moving parts, so eliminate the prospect of mechanical failure. Once the pump flow rate has been set an auto siphon will work continuously with very little maintenance, in fact the only maintenance required is a rotation of the outer screen once or twice per week to deter any roots from growing into the siphon set-up.

How does an Auto Siphon work?...

Using a submersible pump, water is continuously pumped from the fish tank, sump tank, or reservoir, up to the grow bed, as the water level in the grow bed reaches the top of the standpipe in the centre of the siphon set-up, it begins flowing down the standpipe back to the fish tank, sump tank, or reservoir. As it does this it starts a siphon effect that drains the vast majority of the water from the grow bed very quickly, in the same way you would siphon fuel from a car etc. 

As the water level drops it exposes a slot near the bottom of the “Inner Bell” and the siphon begins to suck air, this breaks the siphon effect, stops the flow of water and allows the grow bed to start refilling, therefore starting the flood and cycle all over again.

 

Can also be purchased from our Belmont store.

 

 

Write a review

Your Name:


Your Review: Note: HTML is not translated!

Rating: Bad            Good

Enter the code in the box below: